Nortel Networks BCM1000 - Manual (Page 162)

162 Chapter 9 Starting the system
P0607659 02
1 If the Power LED does not light:
a Disconnect the power cords.
b Check all cables and power connections. Ensure that the ac outlet has power.
c Reconnect the power cords.
2 When the system power is on, and the system has successfully booted, the power and status
LEDs on the faceplates of the media bay modules are lit and remain constant. Refer to the
media bay module sections in
Chapter 2, “Telephony hardware,” on page 89 for a description
of media bay module LED states.
3 You are now ready to connect the hardware to the network.
4 PCI Device Device is present
and the driver is
active driver is not running N/A Device is not
present.
5 PCI Device Device is present
and the driver is
active driver is not running N/A Device is not
present.
Temperature Temperature is
below threshold. N/A Temperature is
in alarm status. N/A
Fans All installed fans are
working N/A There is a
problem with a
fan. N/A
Note: You can monitor the state of the BCM1000 LEDs from your computer. Refer to
“Using the System Status Monitor to monitor LEDs” on page 232 .
Table 25 BCM1000 LED states (Continued)
LED
Label
Description Green LED On Green LED Flash
Red LED On
(Only)
Green LED Off