NEC PD75402A - Manual (Page 190)

179
APPENDIX B. DEVELOPMENT TOOLS
APPENDIX B. DEVELOPMENT TOOLS
The following development tools are available for system development using the
µ
PD75402A:
Language Processor
Host Machine
Ordering Code
(Product Name)
Supply Medium OS
PC DOS TM
(Ver. 3.1)
~
PC-9800 series MS-DOS TM 3.5-inch 2HD
µ
S5A13RA75X
Ver. 3.30
Ver. 5.00 A* 5-inch 2HD
µ
S5A10RA75X
IBM PC/AT TM 5-inch 2HC
µ
S7B10RA75X
PROM Writing Tools
PG-1500 This PROM programmer allows programming, in standalone a mode or via operation
from a host computer, of a singlechip microcomputer with on-chip PROM by
connection of the d board provided and a separately available programmer adapter.
It can program typical 256K-bit to 4M-bit PROMs.
PA-75P402CT PROM programmer adapter for
µ
PD75P402C/CT/GB, used connected to the PG-1500.
PA-75P402GB • PA-75P402CT
... For µ
PD75P402C/CT
• PA-75P402GB ... For
µ
PD75P402GB
PG-1500 controller Connects PG-1500 and host machine via a serial and parallel interface, and controls
the PG-1500 on the host f machine.
Host Machine
Ordering Code
(Product Name)
Supply Medium OS
~
PC-9800 series MS-DOS 3.5-inch 2HD
µ
S5A13PG1500
Ver. 3.30
Ver. 5.00 A* 5-inch 2HD
µ
S5A10PG1500
IBM PC/AT 5-inch 2HC
µ
S7B10PG1500
PC DOS
(Ver. 3.1)
Hardware
Software
* The task swap function, which is provided with Ver.5.00/5.00A, is not available with this software.
Remarks Operation of the relocatable assembler and PG-1500 controller is guaranteed only on the host machines
and operating systems quoted above.
★
RA75X relocatable assembler