NEC PD75402A - Manual (Page 187)

176
CHAPTER 9. INSTRUCTION SET
9.4.13 CPU Control Instructions
HALT
Function: PCC. 2
←
1
Sets the HALT mode (This instruction sets bit 2 of the processor clock control register.).
Note The instruction following the HALT instruction is made an NOP instruction.
STOP
Function: PCC. 3
←
1
Sets the STOP mode (This instruction sets bit 3 of the processor clock control register).
Note The instruction following the STOP instruction is made an NOP instruction.
NOP
Function: Expend one machine cycle without performing any operation.