Palm Pre P100EWW - Manual (Page 187)

Regulatory and safety information 187
Regulatory and safety information
FCC Statements
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This phone meets the FCC Radiofrequency Emission Guidelines and is certified with
the FCC as:
FCC ID: O8F-CASC.
The FCC ID on your Palm phone is located on a label inside the battery compartment.
The battery must be removed as shown below to view the label.
CAUTION Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Antenna Care/Unauthorized Modifications
Use only the supplied integral antenna. Unauthorized antenna modifications or
attachments could damage the unit and may violate FCC regulations.
Industry Canada
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The term “IC” before the equipment certification number only signifies that the
Industry Canada technical specifications were met.
IC: 3905A-CASC
This Class B digital apparatus complies with Canadian ICES-003.
L ' utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) l' utilisateur du dispositif doit étre prêt à accepter
tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de
compromettre le fonctionnement du dispositif.