Konica Minolta Magicolor 5440 DL - Manual (Page 64)

Main Unit Field Service Firmware Upgrade
2-27
II Main
tena
nce
9. After the data has finished being sent, the following message appears on the screen of
the Command Prompt.
10. Then the firmware upgrade starts. Wait until all the upgrade procedure is complete.
NOTE
• Never turn the printer Power Switch OFF and ON while the firmware is being
upgraded.
11. After the firmware upgrade is complete, “FIRMWARE UPDATE TO CONTINUE TURN
OFF THEN ON” is displayed.
12. Turn the printer’s Main Switch OFF and then ON.
13. After the printer has restarted, check that a “READY” message is displayed.
14. From the Menu, select PRINT MENU
→ CONFIGURATION PG and execute the func-
tion. Then, check that the firmware [2] has been upgraded.
☞ For how to execute “CONFIGURATION PG,” see “III Adjustment/Setting.”
4138F2E007DA
4138F2E010DA
FIRMWARE UPDATE
WRITING DATA XX%
4138F2E011DA
FIRMWARE UPDATE
TO CONTINUE
TURN OFF THEN ON
[2]
4138F2E005DA
PRINTER INFORMATION
DATE
TIME
CONTROLLER F/W
ENGINE F/W
BOOT F/W
TOTAL PAGE COUNT
SERIAL NUMBER MM.DD.YYYY
HH.MM
413830F0120000(US)
413850G5110000(US)
413899F0110000
7
******
5450_E.book_PDF.book 27 ページ ２００５年４月１２日 火曜日 午後１２時５４分