Konica Minolta Magicolor 5440 DL - Manual (Page 59)

Firmware Upgrade Main Unit Field Service
2-22
II Main
tena
nce
6. Check the Command Prompt display on the progress of upgrade procedure.
NOTE
• NEVER turn the printer Power Switch OFF and ON until the message “flash update
done” appears on the Command Prompt display.
7. After the firmware upgrade procedure has been completed, turn the printer OFF and
then ON again.
8. Check that the controller firmware version number has been upgraded.
☞ For how to check the firmware version number, see “III. Adjustment/Setting.”
4138fs2540e0
5450_E.book_PDF.book 22 ページ ２００５年４月１２日 火曜日 午後１２時５４分