Konica Minolta Magicolor 5440 DL User Manual
Page 201

Malfunction code
Main Unit Field Service
4-14
IV
T
roub
lshoo
t
in
g
0511
FUSER
ERROR
Abnormally low Fusing
Pressure Roller tem-
perature
• The temperature detected by the Fusing Pres-
sure Roller Thermistor remains lower than the
specified value for a given period of time or
longer.
0520
FUSER
ERROR
Abnormally high Heat-
ing Roller temperature
• The temperature detected by the Heating Roller
Thermistor remains higher than the specified
value for a given period of time or longer.
0521
FUSER
ERROR
Abnormally high Fus-
ing Pressure Roller
temperature
• The temperature detected by the Fusing Pres-
sure Roller Thermistor remains higher than the
specified value for a given period of time or
longer.
13D0
EEPROM1
Parameter Chip failure
• Data, which has been written, is read, checked,
and found faulty; rewriting of the data is then exe-
cuted and the data is checked to be found faulty
during re-reading.
• A count value is found faulty during reading.
• Parameter Chip is detected to be not mounted
during initial mounting detecting sequence.
• Found to be access failure.
13E2
FLASH
WRITE
Flash ROM write error
• Flash ROM writing is found faulty during a check.
13E3
FLASH
DEVICE
Flash ROM device fault
• An erase error occurs during erasing of data in
Flash ROM.
C002
RAM
ERROR
RAM error at Standard
Memory
• RAM error at Standard Memory is detected dur-
ing printer start-up.
C003
RAM error at Extension
Memory
• RAM error at Extension Memory is detected dur-
ing printer start-up.
C013
H/W
ADDRESS
MAC address error
• Invalid Mac address is detected during printer
start-up.
C015
BOOT ROM Boot ROM error
• Boot ROM error is detected during printer start-
up.
C022
NVRAM
ERROR
NVRAM access error
• Correct access to NVRAM is failed during the
printer starting.
C025
CONTROL-
LER ROM
Controller ROM error
• Lead error of destination setting file is detected
during the printer starting.
C026
• Flash ROM access error is detected during the
printer starting.
C027
• Final check sum error is detected during the
printer starting.
C050
HDD
ERROR
HDD access error
• When correct access to the hard disc unit is
failed during access.
C051
HDD DISK
FULL
HDD full error
• Range for user space is full during access to the
Hard Disk unit.
C060
UPDATE
ERROR
Firmware update error
• Firmware update fails to complete correctly dur-
ing update.
LCD1
(Service
call ID)
LCD2/LCD3
(Error
description)
Item
Detection Timing
5450_E.book_PDF.book 14 ページ 2005年4月12日 火曜日 午後12時54分