4 engine, 1 engine toner empty, 2 energy saver – Konica Minolta Magicolor 5440 DL User Manual
Page 117: 3 auto continue, 4 tray chaining, Engine -14, Engine toner empty -14, Energy saver -14, Auto continue -14, Tray chaining -14
![background image](/manuals/157953/117/background.png)
Menu (magicolor 5430 DL /5440 DL)
Main Unit Field Service
3-14
III
Ad
just
men
t/Set
ting
4.4
ENGINE
4.4.1
ENGINE TONER EMPTY
4.4.2
ENERGY SAVER
4.4.3
AUTO CONTINUE
4.4.4
TRAY CHAINING
Function
• Specifies whether to stop or continue printing when a toner empty condition is
detected.
Use
• To specify whether to permit printing upon a toner empty condition.
Setting
/procedure
• The setting can be changed during printing.
• The default setting is “STOP.”
STOP
CONTINUE
Function
• Sets the amount of time before the machine enters Energy Saver mode after the last
print is received or the last key operated.
• The Energy Saver mode is automatically canceled when any of the following opera-
tions is performed:
The machine is restarted.
A print job is received.
Any of the keys on the Control Panel is pressed.
The Front Door or Right Door is opened and closed.
A Tray is opened, then closed.
Use
• To change the amount of time before the machine enters Energy Saver mode.
Setting
/procedure
• The default setting is “30 MINUTES.”
15 MINUTES
30 MINUTES
1 HOUR
2 HOURS
Function
• Enables or disables printing when the size of the media loaded in the tray does not
match that of the print data.
Use
• To select whether to print data on media of another size when the size of the media
loaded in the tray does not match that of the print data.
Setting
/procedure
• The setting can be changed during printing; however, the change is applied begin-
ning with the next job.
• The default setting is “ON.”
ON
OFF
Function
• Enables or disables printing when the current tray runs out of media during the print
cycle by automatically selecting another one loaded with the media of the same size
and type.
• The setting is available only when an optional Lower Feeder Unit is installed.
Use
Setting/
procedure
• The setting can be changed during printing; however, the change is applied begin-
ning with the next job.
• The default setting is “ON.”
ON
OFF
5450_E.book_PDF.book 14 ページ 2005年4月12日 火曜日 午後12時54分