Konica Minolta Magicolor 5440 DL - Manual (Page 174)

Main Unit Field Service Menu (magicolor 5450)
3-71
III
Ad
just
men
t/Set
ting
7.7.11 SECURITY
A. CHANGE PASSWORD
B. LOCK PANEL
Function • Sets the password used for the LOCK PANEL function.
Use • To change the password used for the LOCK PANEL function.
Setting
/procedure 0000: Panel lock function is OFF.
0001 to FFFF: Valid password for panel lock function.
1. Select “SECURITY” and press the MENU/SELECT key.
2. Select “CHANGE PASSWORD” and press the MENU/SELECT key.
3. Set “Desired password (first digit)” with the Up key
U/Down keyV and press the
Right key Z.
4. Repeat the above procedures to set up to fourth digit password.
• The default setting is “0000.”
“0000” to “FFFF”
NOTE
• Make sure to set the password to something other than “0000” when the
“LOCK PANEL” function is set to “ON.”
• If you forget the password, it can be initiated (0000) with SERVICE MODE/
RESTORE PASSWORD.
☞
3-84
Function • Protects the Menu (except the Service menu) and Job Cancel function with a pass-
word.
Use • To make the Menu (except the Service menu) impossible to change unless the cor-
rect password is entered.
Setting
/procedure OFF: Panel Lock function is OFF.
MINIMUM: Panel Lock function is ON. Protect the operation of “INTERFACE MENU”,
“SYS DEFAULT MENU.”
ON: Panel Lock function is ON.
Protect the operation of “PROF/PRINT MENU”, “PRINT MENU”, “PAPER MENU”,
“QUALITY MENU”, “INTERFACE MENU”, “SYS DEFAULT MENU”, “CANCEL JOB
MENU.”
1. Select “SECURITY” and press the MENU/SELECT key.
2. Select “LOCK PANEL” and press the MENU/SELECT key.
3. Select “Desired setting” and press the MENU/SELECT key.
• The default setting is “OFF.”
OFF MINIMUM ON
5450_E.book_PDF.book 71 ページ ２００５年４月１２日 火曜日 午後１２時５４分