Konica Minolta Magicolor 5440 DL - Manual (Page 62)

Main Unit Field Service Firmware Upgrade
2-25
II Main
tena
nce
5. Wait until all of the data is sent. (This takes approximately 2 minutes.)
While the data is being sent, “FIRMWARE UPDATE” and “PROCESSING” are alter-
nately displayed on the screen.
NOTE
• NEVER turn the printer Power Switch OFF and ON while data is being sent.
6. After the data has finished being sent, the following message appears on the screen of
the Command Prompt.
7. A “REBOOTING” message appears in the control panel message display, and the
printer restarts.
8. After the printer has restarted, check that a “READY” message is displayed.
9. From the Menu, select PRINT MENU → CONFIGURATION PG and execute the func-
tion. Then, check that the firmware [2] has been upgraded.
☞ For how to execute “CONFIGURATION PG,” see “III Adjustment/Setting.”
C. What to do if the firmware upgrade fails
• Use the following procedure if the firmware upgrade process is suspended for any
reason. (The printer cannot start until the firmware upgrade process completes
correctly.)
1. Turn OFF the Main switch of the printer.
2. Connect the machine to the PC using a parallel cable.
3. Turn ON the Main switch of the printer while holding down the Down Arrow key V. Con-
tinue holding down the Down Arrow key until the printer starts and “INITIALIZING” is
displayed.
4138F2E007DA
[2]
4138F2E005DA
PRINTER INFORMATION
DATE
TIME
CONTROLLER F/W
ENGINE F/W
BOOT F/W
TOTAL PAGE COUNT
SERIAL NUMBER MM.DD.YYYY
HH.MM
413830F0120000(US)
413850G5110000(US)
413899F0110000
7
******
5450_E.book_PDF.book 25 ページ ２００５年４月１２日 火曜日 午後１２時５４分