Konica Minolta Magicolor 5440 DL - Manual (Page 212)

Main Unit Field Service Malfunction code
4-25
IV
T
roub
lshoo
t
in
g
2.4.26 C060: Firmware Update error (Only for magicolor 5450)
2.4.27 C061: Hold job error/No Duplex unit (Only for magicolor 5450)
C062: Hold job error/No Tray 3 (Only for magicolor 5450)
C063: Hold job error/No Tray 4 (Only for magicolor 5450)
C064: Hold job error/No Memory (Only for magicolor 5450)
Relevant Electrical Parts
Print Control Board (PWB-P)
Step Action
WIRING DIAGRAM
Control Signal
Location
(Electrical
Component)
1
Turn OFF the Power Switch of the printer and
turn it ON again (Restart of the printer.)
- -
2
Check the cable that has been used for update of
the firmware for proper connection and correct as
necessary.
- -
3 Update the firmware again. - -
4
Check the PWB-P connector for proper connec-
tion and correct as necessary.
- -
5 Change PWB-P - -
Relevant Electrical Parts
Print Control Board (PWB-P) Mechanical Control Board (PWB-A)
Step Action
WIRING DIAGRAM
Control Signal
Location
(Electrical
Component)
1
Turn OFF the Power Switch of the printer and
turn it ON again (Restart of the printer.)
- -
2
Return to the same state as the device configura-
tion when job was held.
- -
3
Check the options that are mounted on the
printer for proper connection and correct as nec-
essary.
- -
4
Check the PWB-A connector for proper connec-
tion and correct as necessary.
- -
5 Delete the job hold in “PROOF/PRINT MENU.” - -
5450_E.book_PDF.book 25 ページ ２００５年４月１２日 火曜日 午後１２時５４分