Konica Minolta Magicolor 5440 DL - Manual (Page 58)

Main Unit Field Service Firmware Upgrade
2-21
II Main
tena
nce
3. Firmware Upgrade
3.1 Print Control Board (PWB-P) Firmware Upgrading
3.1.1 Upgrade procedure (magicolor 5430 DL/5440 DL)
1. Connect the machine to the PC using an Ethernet cable.
2. From the Menu, select SPECIAL PAGES → PRINT CONFIG PAGE and execute the
function. Then, check the IP address [1] of the machine.
☞ For how to execute “PRINT CONFIG PAGE,” see “III Adjustment/Setting.”
3. Copy the firmware data and upgrading program to any directory on the PC.
4. Start the Command Prompt and go to the directory in which the firmware data is
stored.
5. Execute the “flashupdate” command to start the transfer of firmware data.
(The screen shown below indicates that the firmware data resides on the C drive.)
4138fs2527c0
[1]
Data to be upgraded Command
Application flashupdate -r XXX.XXX.XXX.XXX vxworks.z
BOOT flashupdate -b XXX.XXX.XXX.XXX ******.flt
XXX.XXX.XXX.XXX : IP address of the machine
******
: Firmware data file name
4138fs2539e0
5450_E.book_PDF.book 21 ページ ２００５年４月１２日 火曜日 午後１２時５４分