Siemens AC75 - Manual (Page 62)

AC75 AT Command Set
2.14 AT^SCFG
s
AC75_ATC_V01.002 Page 62 of 569 10/30/06
Confidential / Released
Unsolicited Result Codes
URC 1
^SCFG: "AutoExec", , , ,
,
If the event specified with occurs and the related AT command line is executed this URC
is issued.
URC 2
^SYSSTART AIRPLANE MODE
This URC is issued each time the Airplane mode is activated, no matter whether Airplane mode is set with
parameter ="on" or ="on". The URC notifies the user that only the AT commands supported
in Airplane mode are accessible. After leaving the Airplane mode the URC "
^SYSSTART
" indicates that the
ME has returned to Normal mode and the full set of AT commands is accessible again.
Write Command
Userware debug interface:
AT^SCFG=
"Userware/DebugInterface"[, , [, ]]
Response(s)
^SCFG:
"Userware/DebugInterface", , ,
OK
ERROR
+CME ERROR
Write Command
Userware mode:
AT^SCFG=
"Userware/Mode"[, , , ]
Response(s)
^SCFG:
"Userware/Mode", , ,
OK
ERROR
+CME ERROR
Write Command
Standard output of userware
AT^SCFG=
"Userware/Stdout"[, [, ][, ][, ]]
Response(s)
^SCFG:
"Stdout" , [, [, [, ]]]
OK
ERROR
+CME ERROR
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
- + + + + + + ± ± -