Siemens AC75 - Manual (Page 419)

AC75 AT Command Set
15.1 AT^SRSA
s
AC75_ATC_V01.002 Page 419 of 569 10/30/06
Confidential / Released
Device identification
Arbitrary number assigned on RSA activation by the host. Used for all subsequent RSA communication (AT
commands and URCs) during the activated session. Different numbers shall be used for SAP server and client.
1...100
SIM usage scheme of the AC75
Direct switch from SAP server to SAP client mode and vice versa is not supported.
0
(P) Local SIM
If this parameter value is used with write command meaning depends on
parameter .
1 SAP server
Enables Remote SIM Access and configures the AC75 as SAP server.
The SAP server waits for CONNECT_REQ messages sent from the SAP client
until the right is negotiated. Once the SAP client sends a
CONNECT_REQ message with 276, the SAP server dereg-
isters from the network and then acts as SIM card reader.
However, under the following conditions the SAP server will not react to
CONNECT_REQ messages:
• during any calls (voice or data),
• if a GPRS context is activated,
• if Remote-SAT interface is activated (
AT^SSTA
) and a proactive command
is ongoing.
2 SAP client
Enables Remote SIM Access and configures the AC75 as SAP client.
The SAP client starts sending CONNECT_REQ messages periodically, until
the right is negotiated. The intervals between sending
CONNECT_REQ messages are set with . The SAP client
deregisters from the network if a local SIM was used before and switches to
the remote SIM after receiving all of the following messages from the SAP
server:
• the SAP message CONNECT_RESP,
• the SAP message STATUS_IND
• and, finally, the SAP message ATR_RESP received after the appropriate
request was issued by the client.
However, under the same conditions listed above for =1, the SAP
client will not send CONNECT_REQ messages, nor will it switch to the remote
SIM.
Serial multiplexer channel number
Logical channels 2 and 3 can be reserved for RSA traffic on serial interface multiplexer. Multiplex mode shall be
enabled before RSA activation via
AT+CMUX
.
Note:
Number of multiplex channels is implementation specific, please refer to
AT+CMUX
and the multiplex documen-
tation supplied with the AC75. If for instance three logical channels are implemented these are referenced as
numbers 1 - 3. The selected multiplexer channel is dedicated to the RSA communication. However, it is not pos-
sible to reserve logical channel number 1 for RSA traffic because only on this channel the AC75 can perform
circuit switched data transfer, e.g. FAX or data calls. If no channel is specified the ME uses the channel on which
the command was issued. If RSA is activated from Java this parameter can be either 2 or 3. Multiplexer is not
used in this use case.
(num)
(num)
(num)