Siemens AC75 - Manual (Page 210)

AC75 AT Command Set
8.9 AT^MONI
s
AC75_ATC_V01.002 Page 210 of 569 10/30/06
Confidential / Released
8.9 AT^MONI Monitor idle mode and dedicated mode
The
AT^MONI
command supplies information of the serving/dedicated cell. There are two ways to retrieve the
information: once on request by using the execute command or automatically every seconds by using
the write command. To stop the periodic presentation type "AT" or "at".
Syntax
Parameter Description
Display period in seconds
1...254
Notes
• The two header lines (see Section 8.9.1 , AT^MONI responses ) are output after every ten data lines.
• The length of following output lines exceeds 80 characters. Therefore a terminal program may draw a carriage
return on a screen. However, this is not part of the response.
• If the ME is Java controlled, periodic retrieval of cell information using the write command
AT^MONI
= is not supported. If periodic cell information is required simply repeat the execute com-
mands at regular intervals.
• The parameters LAC and cell are presented as hexadecimal digits, the remaining parameters are composed
of decimal digits.
Test Command
AT^MONI=?
Response(s)
^MONI:
(list of supported s)
OK
Exec Command
AT^MONI
Response(s)
See: Section 8.9.1 , AT^MONI responses
OK
Write Command
AT^MONI=
Response(s)
See: Section 8.9.1 , AT^MONI responses
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - - -
(num)