2 at^scpin pin configuration, At^scpin, Ac75 at command set – Siemens AC75 User Manual
Page 509
AC75 AT Command Set
20.2 AT^SCPIN
s
AC75_ATC_V01.002
Page 509 of 569
10/30/06
Confidential / Released
20.2
AT^SCPIN Pin Configuration
The
write command serves to add (or remove) and configure pins.
Syntax
Parameter Description
0
Close pin
1
Open pin
Pin identifier
0
GPIO1
1
GPIO2
2
GPIO3
3
GPIO4
4
GPIO5
5
GPIO6
6
GPIO7
7
GPIO8
8
GPIO9
9
GPIO10 - The GPIO10 pin can be used either as GPIO or as pulse counter. If
configured as GPIO, the pulse counter option cannot be enabled. Vice versa,
if configured as pulse counter the GPIO option is not available. See
and
for further details on the pulse counter.
Parameter
is mandatory when opening a pin, but can be omitted when closing a pin
0
Input
1
Output
Test Command
AT^SCPIN=?
Response(s)
^SCPIN:
(list of supported
s), (list of supported
s), (list
of supported
OK
Write Command
,
]
Response(s)
OK
ERROR
+CME ERROR:
Reference(s)
PIN
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS
-
+
+
+
+
+
+
-
+
-
(num)
(num)
(num)