Siemens AC75 - Manual (Page 458)

AC75 AT Command Set
18.4 AT+CLVL
s
AC75_ATC_V01.002 Page 458 of 569 10/30/06
Confidential / Released
18.4 AT+CLVL Loudspeaker volume level
Syntax
Parameter Description
Loudspeaker Volume Level
0...4
(D)
Notes
• The write command can only be used in audio mode 2 - 6.
• The values of the volume steps are specified with the parameters
[0],...
brate>
[4] of the
AT^SNFO
command.
• As an alternative to
AT+CLVL
, you can use
AT^SNFO
and
AT^SNFV
. The parameter is identical with
used by both commands.
• Any change to (or ) takes effect in audio modes 2 to 6. That is, when you change
(or ) and then select another mode with
AT^SNFS
, the same step will be applied.
The only exception is audio mode 1 which is fixed to =4 (or accordingly =4).
• (or ) is stored non-volatile when the ME is powered down with
AT^SMSO
or reset with
AT+CFUN
=1,1.
Test Command
AT+CLVL=?
Response(s)
+CLVL:
(list of supported s)
OK
Read Command
AT+CLVL?
Response(s)
+CLVL:
OK
ERROR
+CME ERROR:
Write Command
AT+CLVL=
Response(s)
OK
ERROR
+CME ERROR:
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 - + + + + + + - + -
(num)