1 at^moni responses, At^moni responses – Siemens AC75 User Manual

Page 211

AC75 AT Command Set

8.9 AT^MONI

AC75_ATC_V01.002

Page 211 of 569

10/30/06

Confidential / Released

• If the radio cell changes during a connection, the parameters PWR, RXLev and C1 of the 'Serving Cell' part

cannot be updated under certain conditions and therefore, are displayed as "-" (for conditions see also

). This is because the MS does not update the cell selection and reselection parameters since, in

this mode, they are not relevant for operation. When the connection ends, and the mobile is back to IDLE

mode, correct values will be given.

If the radio cell changes during a connection, it normally takes 1 or 2 seconds to update the parameters cell,

NCC and BCC. Until the information is received from the new base station, the default values will be shown

instead: cell="0000", NCC="-", BCC="-".

• If the BS supports frequency hopping during a connection, the dedicated channel (parameter chann) is not

stable. This mode is indicated by chann = 'h'.

• To some extent, the cell monitoring command

covers the same parameters. The receiving level,

for example, can be queried with both commands. Yet the resulting values may be slightly different, even

though obtained over a time period of a few seconds. This is quite normal and nothing to worry about, as the

cell information is permanently updated.

• For compatibility with earlier products and to support legacy applications, any input character may be used to

stop the output in certain cases (depending on the settings of

and

8.9.1

AT^MONI responses

ME is not connected:

a) ME is camping on a cell and registered to the network:

b) ME is camping on a cell but not registered to the network (only emergency call allowed):

c) ME camping on a cell, but searching for a better cell (cell reselection):

d) ME is searching and could not (yet) find a suitable cell:

ME is connected (Call in progress):

Columns for Serving Cell:

Serving Cell I Dedicated channel