Siemens AC75 - Manual (Page 257)

AC75 AT Command Set
10.1 AT^SICS
s
AC75_ATC_V01.002 Page 257 of 569 10/30/06
Confidential / Released
Parameter Description
0...5 Internet connection profile identifier.
The identifies all parameters of a connection profile, and,
when a service profile is created with
AT^SISS
the needs
to be set as "conId" value of the
AT^SISS
parameter .
Internet connection parameter.
“conType“
Type of Internet connection.
For supported values of refer to
Type>
.
“alphabet“ Selects the character set for input and output of string parameters within a pro-
file.
The selected value is bound to the specific profile. This means that different
profiles may use different alphabets. Unlike other parameters the alphabet can
be changed no matter whether the value "conType" has been
set.
For supported values of refer to
alphabet>
.
“user“ User name string: maximum 32 characters (where "" is default).
“passwd“ Password string: maximum 32 characters (where ***** is default).
If is "MsChapV1" then the maximum password
length is 16 characters.
“apn“ Access point name string value: maximum 100 characters (where "" is default).
“inactTO“ Inactivity timeout value in seconds: 0 ... 2 16 -1, default = 20
Number of seconds the bearer remains open although the service no longer
needs the bearer connection.
Do not set the timeout value below 3 sec. This may result in problems when
using the (set in the last
AT^SISW
command to terminate an
upload data stream).
The value -1 indicates that, after opening the bearer with
AT^SICO
, the inac-
tivity timeout is currently disabled. Closing the bearer with
AT^SICC
restores
the previously set "inactTO" value of the concerned connection profile.
“calledNum“ Called BCD number.
“dataRate“ Data rate.
For supported values of refer to
aRate>
.
“dataType“ Data call type.
For supported values of refer to
dataType>
.
Write Command
AT^SICS=
, ,
Response(s)
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
- + + + + + + - + -
(num)
(str)