Siemens AC75 - Manual (Page 517)

AC75 AT Command Set
20.8 AT^SCCNT
s
AC75_ATC_V01.002 Page 517 of 569 10/30/06
Confidential / Released
20.8 AT^SCCNT Configure Pulse Counter
The
AT^SCCNT
write command serves to configure the GPIO10 pin as pulse counter. The pulse counter is
designed to measure signals from 0 to 1000 pulses per second.
Remember that if the GPIO10 line is configured as GPIO (see
AT^SCPIN
) any attempt to activate the pulse
counter will be rejected. Vice versa, if the pulse counter is opened the GPIO10 line cannot be configured as
GPIO.
See also [2] for further detail on the pulse counter.
Syntax
Unsolicited Result Code
^SCCNT:
The URC applies only to the Limit counter mode set with parameter =1. It is delivered once the pulse
counter has completed counting the number of pulses requested with parameter .
Parameter Description
0 Close pulse counter
1 Open pulse counter
Test Command
AT^SCCNT=?
Response(s)
^SCCNT:
(list of supported s), (list of supported s), (list of supported s)
OK
Read Command
AT^SCCNT?
Response(s)
^SCCNT:
, [, ]
OK
ERROR
+CME ERROR:
Write Command
AT^SCCNT=
, [, ]
Response(s)
OK
ERROR
+CME ERROR:
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - + -
(num)