5 at^siso internet service open, At^siso, Ion opened with – Siemens AC75 User Manual
Page 274: Tivated via, Write command, Ac75 at command set
AC75 AT Command Set
10.5 AT^SISO
s
AC75_ATC_V01.002
Page 274 of 569
10/30/06
Confidential / Released
10.5
AT^SISO Internet Service Open
The
write command starts the Internet session configured by the service profile. All further steps
needed to control the session depend on whether you are using URC mode or polling mode. The
read
command returns the current status of all services.
URC mode:
If the service opens successfully, the URCs "
" will trigger the action to follow, either writing
data with
or reading data with
. To terminate an upload data stream set the
within the last
command. If the URCs notify that a data transfer has been successful ("
: x, 2" or
: x, 2"), the service can be closed with
. If a special event occurs, e.g. an error or a warning,
after opening or while using a service then the URC type "
" will be delivered.
Polling mode:
After opening the service, all progress information needed to control the session shall be explicitly requested by
the host application. The particular sequence of AT commands varies depending on the service used. The fol-
lowing list summarizes, by way of an example, the steps normally involved in managing an upload or download
job.
• Upload (Socket, FTP, HTTP, SMTP):
- Enter the
command, e.g. AT^SISO=9.
, specify
, e.g. AT^SISW=9,20. Check resulting response for
. Optionally, check error with
, e.g. AT^SISE=9. If necessary, repeat the
sequence several times.
- Enter last
If Socket service: Query available data with
, e.g. AT^SISR=9,1430.
, e.g. AT^SISI=9, if necessary several times until
=6
("Down").
- Check error with
- Close service with
, e.g. AT^SISC=9.
• Download (Socket, FTP, HTTP, POP3):
- Enter the
command, e.g. AT^SISO=9.
- Enter
, specify
, e.g. AT^SISR=9,1000. Check resulting response for
. If necessary, repeat the sequence several times until
= -2 (end
of data) or ERROR.
- Check error with
- Close service with
, e.g. AT^SISC=9.
• Socket service (upload and download possible in one session):
- Recommended: Set
=2 to enable extended error text.
- Enter the
command, e.g. AT^SISO=9.
- Enter
or
AT^SISR=9,20 or AT^SISW=9,20. Check resulting response for
. If necessary, repeat the sequence several times.
- Check error with
- If write action: Enter last
command and enable
If Socket service: Query available data with
, e.g. AT^SISR=9,1430.
- Close service with
, e.g. AT^SISC=9.
Syntax
Test Command
AT^SISO=?
Response(s)
OK