Siemens AC75 - Manual (Page 276)

AC75 AT Command Set
10.5 AT^SISO
s
AC75_ATC_V01.002 Page 276 of 569 10/30/06
Confidential / Released
6 Down
This state is entered if
- the service has successfully finished its session (see note on Socket),
- the remote peer has reset the connection or
- the IP connection has been closed because of an error.
If a service in this state be sure to close it with
AT^SISC
before reopening it.
Socket state identifier.
1
Socket not assigned, i.e. no TCP/UDP connection active.
2 Socket assigned as CLIENT.
3 Socket assigned as LISTENER.
4 Socket assigned as SERVER.
Number of bytes received via
AT^SISR
since last successful
AT^SISO
write command.
Number of bytes sent via
AT^SISW
since last successful
AT^SISO
write command.
Recently used local IP address in dotted-four-byte format and TCP port, separated by colon, e.g.
"192.60.10.10:80".
Remote IP address in dotted-four-byte format and TCP port, separated by colon, e.g. "192.60.10.10:80".
Notes
• If the bearer cannot be established and
AT^SISO
returns an error there might be a general GSM/GPRS prob-
lem. To identify the reason you can take advantage of the
AT+CEER
command. Using
AT+CEER
is especially
recommended when the parameter of the
AT^SISE
command equals 0.
• As in polling mode no error URCs are available you are advised to integrate the commands
AT^SISI
and
AT^SISE
into the command sequences for upload and download jobs. So, the
AT^SISO
command may be
followed by
AT^SISI
to check that the service has entered the =4 before sending
AT^SISR
or
AT^SISW
. This helps you to detect errors even though the "
^SIS
" URCs are disabled. A typical example is
that the service fails to be opened because the service profile contains a wrong destination address. In such
a case, after opening with
AT^SISO
and OK response, the service quickly enters the states =2,
4 and 6, with an error being returned no earlier than after sending the first
AT^SISR
or
AT^SISW
command.
In URC mode, an error URC, such as "Host not found" would be received in this situation, but in polling mode
the only way to detect the state is using
AT^SISI
or, alternatively,
AT^SISO
.
• If the user rapidly closes and opens TCP/IP connections based on the embedded TCP/IP stack the service
may display the error "No buffer space available", meaning that all TCP/IP socket resources are exhausted.
In the worst case, opening further TCP/IP connections is locked for up to 60 seconds.
• The Socket Listener may not work properly if the service is re-opened shortly after having closed the Socket
Listener. To ensure that the service works correctly the host is required to wait at least two minutes before re-
opening a Listener.
(num)
(num)
(num)
(str)
(str)