Siemens AC75 - Manual (Page 389)

AC75 AT Command Set
13.17 AT+CSMS
s
AC75_ATC_V01.002 Page 389 of 569 10/30/06
Confidential / Released
Broadcast Type Messages:
0
Type not supported
1 Type supported
Notes
• If CSMS mode is switched from Phase 2+ to Phase 2 and one or more
AT+CNMI
Parameter are Phase 2+
specific a '+CMS ERROR: unknown error' will appear. It is recommended to switch the
AT+CNMI
Parameters
to Phase 2 specific values before entering Phase 2.
• Phase 2+ ( =1) must be set before the following features can be used:
- Configuring procedures for indicating received short messages with the
AT+CNMI
parameters =2 or
=3 and =1.
- Acknowledging incoming short messages with
AT+CNMA
.
- Receiving Status Reports and acknowledging them with
AT+CNMA
.
(num)