Siemens AC75 - Manual (Page 392)

AC75 AT Command Set
13.20 AT^SCMS
s
AC75_ATC_V01.002 Page 392 of 569 10/30/06
Confidential / Released
13.20 AT^SCMS Send Concatenated Short Messages
Sending a concatenated message is similar to sending a "normal" message, except that each segment of the
concatenated message must be identified by the additional parameters , and . To send all
segments of the message one by one, the
AT^SCMS
write command must be executed for each segment.
The write command transmits one segment of a concatenated short message from TE to network (SMS-SUB-
MIT).
After invoking the write command wait for the prompt ">" and then start to write the message. To send the mes-
sage simply enter . After the prompt a timer will be started to observe the input.
To abort sending use . Abortion is acknowledged with "OK", though the message will not be sent.
The message reference is returned to the TE on successful message delivery. The value can be used to
identify the message in a delivery status report provided as an unsolicited result code.
Syntax
Notes
• See notes provided for
AT+CMGS
.
• Command is only available if
AT+CMGF
=1.
Test Command
AT^SCMS=?
Response(s)
OK
Write Command
Command syntax for text mode (see
AT+CMGF
=1):
AT^SCMS=
[, ], , , , Text can be entered /
Response(s)
+CMGS:
[, ]
OK
If sending fails
ERROR
+CMS ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS + + + + + + + - - -