Fax commands, 1 fax parameters, 1 fax result codes – Siemens AC75 User Manual
Page 352: Fax commands 12.1 fax parameters, Fax result codes, Table 12.1
AC75 AT Command Set
12. FAX Commands
s
AC75_ATC_V01.002
Page 352 of 569
10/30/06
Confidential / Released
12.
FAX Commands
This chapter describes the AT commands used for fax communications. Please note that fax related commands
are not supported by Java.
If the ME is acting as a fax modem for a PC based fax application (e.g. "WinFax") it is necessary to select the
proper Service Class (Fax Class) provided by the ME. The ME reports its Service Class capabilities, i.e. the cur-
rent setting and the range of services available. This is provided by the
command.
Service Classes supported by the ME:
During an active fax connection the AT parser functionality on the used channel is limited to the AT commands
which according to the ITU V.250 and T.31 specifications are mandatory for fax communications. The functions
of these AT commands are usually supported by commonly used fax applications.
12.1
FAX parameters
This section describes the parameter
used by some of the fax-specific AT commands. To find out the
value(s) actually supported by the
parameter use the test commands either in on-hook or off-hook mode.
Parameter Description
Modulation scheme
3
V21 Ch2 - 300 bps
24
V.27ter - 2400 bps
48
V.27ter - 7200 bps
72
V.29 - 7200 bps
96
V.29 - 9600 bps
Note
and
, parameter
never support
=3.
12.1.1
Fax Result Codes
Table 12.1: Fax Result Codes
Parameter
Service class
Reference, Standard
0
Data modem
e.g. TIA/EIA-602 or ITU V.250
1
Service Class 1
EIA/TIA-578-A
(num)
Result Code
Meaning
+FCERROR
This facsimile error message notifies the DTE that the DCE has
received a different signal (tone or carrier) than expected. This
allows the DTE to recover by requesting the DCE to look for an
alternative tone or carrier signal.