Use the fuser jam-release lever to pump the rem, Repeat step6 and step7 three or four times un, Clean the oil removal tool with a towel and st – IBM S544-5361-01 User Manual

Page 97

Chapter 5. Replacing Supplies

5–23

7. Use the fuser jam-release lever to pump the remaining oil from the fuser

into the oil bottle holder. You will need to pump the lever approximately 50
times.

8. Repeat step 6 and step 7 three or four times until you have removed most

of the oil from the fuser.

9. Replace the inner seal (see page 5–22) on the oil recycle bottle and cap

the bottle.

10. Clean the oil removal tool with a towel and store it in the box in which it was

shipped.