Replacing the fuser access door, Make sure that the feeder access door is open, Hold the fuser access door with the top edge po – IBM S544-5361-01 User Manual

Page 103: Grasp the tab at the top of the strap on the fu, Replacing the fuser access door –29

Chapter 5. Replacing Supplies

5–29

Replacing the Fuser Access Door

Use the following procedure to replace the fuser access door on the printer.

1. Make sure that the feeder access door is open.

2. Hold the fuser access door with the top edge pointing down and align the

2 pivots on the door with the 2 brackets on the frame (the door pivot on the
right has a tab that aligns with the cutout [1] in the right bracket). Slide the
door to the right and rotate it up.

3. Grasp the tab at the top of the strap on the fuser access door [1]. Insert the

tab into the cutout in the printer frame [2] and slide the tab down until the
top of the tab [3] aligns with the hole in the frame [4]. Push the tab into the
hole in the frame and lock it in place.