IBM S544-5361-01 - Manual (Page 109)

Chapter 5. Replacing Supplies
5–35
7. Press the green tab [1] on the right side of the photoconductor drum
cartridge and pull the drum cartridge out [2] of the printer onto the shield.
Installing a New Photoconductor Drum Cartridge
Use the following procedure to install a new photoconductor drum cartridge in
the printer.
1. Get a new photoconductor drum cartridge and remove it from the
protective bag.
Notes:
1) Do not open the protective bag or the photoconductor drum
cartridge cover until you are ready to install the cartridge in the
printer.
2) Do not expose the photoconductor drum cartridge to or store it in
direct sunlight.
3) Do not remove the orange protective shield from the cartridge until
you are instructed to do so.
2. Use the arrow on the cartridge as a guide to align the photoconductor drum
cartridge with the arrow on the printer. The orange photoconductor drum
shield rests on a V-shaped cutout on the printer.
Do not use excessive force on the shield when you handle the
photoconductor drum cartridge. If you do, you may scratch the