Connecting the watchdog line, Connecting the watchdog line to nv6120t, Connecting the watchdog line to nv6000t – AVer NXU8000 User Manual
Page 29
17
2.5.5
Connecting the Watchdog line
The DVR program constantly monitors its operation. Connecting the NV6120T/NV6000T
(6240T/6480T) /NV8416T to the motherboard reset switch panel, enables the unit to restart
automatically and reset the system when an error has been detected.
i
If more than one NV6120T/NV6000T (6240T/6480T)/NV8416T card is installed, connect
the watchdog line at last card.
2.5.6
Connecting the Watchdog line to NV6120T
1.
Look for the labeled RESET SW switch lead and connect it to the NV6120T card reset pin.
2.
Connect the supplied Watchdog line to the NV6120T card watchdog pin and the other end to the
motherboard RESET SW panel. If you are not sure, please refer to the motherboard user manual.
3.
You may now replace back the PC cover and connect all the cables.
NV6120T
Reset SW lead
Watchdog line
2.5.7
Connecting the Watchdog line to NV6000T
4.
Look for the labeled RESET SW switch lead and connect it to the NV6000T card reset pin.
5.
Connect the supplied Watchdog line to the NV6000T card watchdog pin and the other end to the
motherboard RESET SW panel. If you are not sure, please refer to the motherboard user manual.
6.
You may now replace back the PC cover and connect all the cables.
NV6000T
Reset SW lead
Watchdog line