AVer NXU8000 - Manual (Page 226)

214
- TV Out
i
Alarm TV Out func tion doesn’t support for NVR server.
Switch to only display the video on TV from where the alarm is activated.
- Enlarge Camera View
Switch to only display video in Preview/Advanced mode from where the alarm is activated.
- Send E-mail
Send an electronic text message. To setup click Detail (see also To Setup Send E-mail ).
- File Transmission via FTP
Upload file to remote computer thru FTP (File Transfer Protocol). To setup click Detail (see also
To Setup FTP ).
- Start Recording
Record the video from the selected camera. To setup click Detail (see also To Setup Alarm
Recording ).
- Alarm SOP (Standard Operation Procedure)
List the instructions to inform the person of what to do when the alarm is activated. To setup
click Detail (see also
To Setup Alarm SOP ).
- Send to CMS (Central Management System)
Enable/disable the selected camera to send video to CMS when the alarm is activated (see
also
To Setup CMS Setting )
To Setup Send E-mail Setting
Beside the Send Email check box, click Detail. In the E-mail Setting dialog box, click OK to exit
and save the setting and Cancel to exit without saving the setting.
i
Gmail is supported now.
- Mail Server
Enter the SMTP Server and port. If your e-mail system requires user identification, enable
Authentication check box and enter User ID and Password.
- Mail
To check if it is working, click Test Account button.
 From: Enter the sender e-mail address.
 To and CC: Enter the recipient email address and separate it with comma or a semicolon
(;).
 Subject: Enter the message title.
 Message: Type the message.
- Email Notice Setting
 Notice Interval: Set the period of time before it sends another e-mail notice.
 Embedded image: Select the sending image
’s size and set the number of frames.
 Attach image when sensor is triggered: When the sensor is triggered, the system will
capture the image and send the image to the certain e-mail address with the alarm
message.
i If the alarm is not triggered by sensor, the system will depends on the setting of motion
detected, video loss, audio detect, and sensor in alarm setting to send the alarm image and
alarm message.
- Modem Dial up Setting
User may set the time to disconnect automatically, just enable the Auto Disconnect after
check box and set time.