AVer NXU8000 - Manual (Page 182)

170
5.9.4 To Setup Send E-mail Setting
Next to the Send Email check box, click Detail. In the E-mail Setting dialog box, click OK to exit and
save the setting and Cancel to exit without saving the setting.
i
Gmail is supported now.
(1)
(2)
(3)
(4)
(1) Mail Server
Enter the SMTP Server and port. If your e-mail system requires user identification, enable
Authentication check box and enter User ID and Password.
(2) Mail
To check if it is working, click Test Account button.
 From: Enter the sender e-mail address.
 To and CC: Enter the recipient email address and separate it with comma or a semicolon (;).
 Subject: Enter the message title.
 Message: Type the message.
(3) Email Notice Setting
 Notice Interval: Set the period of time before it sends another e-mail notice.
 Embedded image : Select the
sending image’s size and set the number of frames.
 Attach image when sensor is triggered: When the sensor is triggered, the system will
capture the image and send the image to the certain e-mail address with the alarm message.
i If the alarm is not triggered by sensor, the system will depends on the setting of motion
detected, video loss, audio detect, and sensor in alarm setting to send the alarm image and
alarm message.
(4) Modem Dial up Setting
If you are using dial up modem, enable Auto Dial up check box and select the modem name. You
may also set the time to disconnect automatically, just enable the Auto Disconnect after check
box and set time.