Ensor, Etting – AVer NXU8000 User Manual
Page 168
156
5.7
Sensor Setting
The I/O device must be installed to use this function. The DVR system also support external I/O box
and user can install external sensors. For external sensor setting, please referring to the sensor
vendor user’s manual.
To Set the Sensor Setting:
1. Click the drop-down list and select the sensor ID number.
2. Enter sensor name.
3. The system automatically detects the card and input number. In the Content section, enter sensor
description.
4. In the test section, click Test to check the sensor status. Red is high and Green is low.
5. Click OK to exit and accept the setting and Cancel to exit without saving the setting.
6. Click External IO to configure external I/O device if it is available (see also
). When external
I/O is set and it will be available in drag down list for selecting.