AVer NXU8000 User Manual
Page 225
213
System Reboot: when the DVR system reboot without abnormal condition, the system
will send out the alarm message.
Abnormal Reboot: when the DVR system reboot in irregular condition, the system will
send out the alarm message.
Recording is switched off: when the recording has been stopped, the system will send
out the alarm message.
Network is switched off: when the network connection of DVR system is lost, the system
will send out the alarm message.
Hard Disk failed:
when the hard disk can’t work normally, the system will send out the
alarm message.
Temperature: set a temperature limited of system for system to alarm. When DVR system
temperature is over the temperature limited, the DVR system will send out the alarm.
VGA Temperature: set a VGA temperature limited for alarm. When VGA temperature is
over the limited that user has set, the DVR system will send out the alarm.
Illegal Entry: any objects move between selected regions which user has set up in
Object Counting section (see also
, the system will send out the alarm.
Select the entry (object moves from region 1 to 2 or from region 2 to 1) and camera for
system alarm detection.
- Enable/disable the POS Keyword check box, to scan the data from the POS if it matches the
keyword (see also
- Enable/disable the Alarm Message check box, to active with external alarm message by your
own program. For the detail configuration, please contact the local reseller.
6.
In (5) Alarm Reset, click the camera number (use and to select the alarm) to set the reset
condition of alarm. Once alarm is reset, all alarm action will stop at the moment. If the sensor
normal status is high, set the sensor condition to low.
7.
In (6) Action, you may now set the alarm action for the system to perform when the alarm
condition is activated.
- Launch EMap
Display mini Emap screen.