AVer NXU8000 - Manual (Page 133)

121
 Using URL: In the IP Camera Settings dialog box, select to connect using URL and then
enter the URL of the IP camera(If you are not sure of the Protocol or URL info, please refer
to the IP camera manual or contact your IP camera local distributor.). If IP camera requires
user identification, enable Authentication check box and enter ID and Password. To
enable audio, click Enable Audio check box. IP Camera Information section displays the
selected camera
’s firmware version. Click Save & Exit to save the setting and leave the
setup window, but no connection with IP camera. To connect IP camera, click Connect
button. Click OK to save the setting but not exit the setup window. To cancel the setting,
click Cancel.