AVer NXU8000 - Manual (Page 180)

168
5.9.1 To Setup Alarm Relay
1. Next to the Relay Output check box, click Detail.
2. In the Alarm Relay dialog box, select from the available relay list and in the ON column, set to
enable/disable the relay operation when the alarm is activated.
In the Retrieve time check box, you may enable/disable to extend the relay operation time and set
the duration in second.
3. Click OK to exit and accept the setting and Cancel to exit without saving the setting.
5.9.2 To Setup the Alarm Sound Setting
1. Next to the Play Warning Sound check box, click
Detail.
2. In the Alarm Sound Setting dialog box, click to
select other wav file from other source or folder,
Play to listen, Record to make a new copy of a
sound.
3. Select the Play Mode.
 Interrupt: when receive the new alarm warming,
immediately play new warming sound.
 Play by sequence: when receive the new alarm
warming, play after the on playing alarm
warming.
4. If you click Record, you will be prompted if you want
to replace the file. Click OK to continue and
Cancel to discontinue.
5. When the Sound Recorder appears, use the record
control panel to record, stop, play, rewind and
forward. If you want to keep the existing file, click
File >
Save As…, enter filename and click Save.
Make sure you have microphone connected to your
PC.
6. Click OK to exit and accept the setting and Cancel to exit without saving the setting.