Biamp LTR - Manual (Page 92)

Nexia Manual LTR
Front Panel Indicators: The Front Panel Indicators (I/O, Com, & Status) are 2-color LEDs.
The following table lists their behavior:
All LEDs green Normal operating state. Configuration was successful (if applicable).
Device is in a stable state awaiting commands.
I/O LED red Internal audio hardware error.
Com LED red Serial Port error.
Ethernet error.
CAN Bus error.
No IP address defined (cleared by setting IP address).
Status LED red Configuration error.
Last configuration unsuccessful (cleared by 'reset/initializing' the
device). Operating systems resource error.
File system error.
DSP error.
All LEDs blinking Operating system is not executing. Device must be power cycled.
Status LED blinking The firmware has attempted to perform an illegal operation. Device
must be power cycled.
Control Dialogs
PM Input 4 Channel
NEXIA PM hardware is always represented in the Layout as three separate
blocks, two for input connections and one for output connections. Between
these blocks can be placed virtually any of the other available NEXIA mixing,
routing, and processing blocks (component objects). Like other component
objects, NEXIA PM blocks can be placed into the Layout either from the
78