Ip address commands, Get/set ip address – Biamp LTR User Manual
Page 211
System Control
Windows® is a registered trademark of Microsoft Corporation.
IP Address Commands
Nexia has some useful IP and reset tools that may be useful when returning to older systems for
service work.
Nexia will automatically output its IP Address through the RS-232 port when it is powered up and
functioning. Simply have a straight through RS-232 cable connected to Nexia and a PC with
HyperTerminal running. When Nexia is powered up it will print the data in the HyperTerminal
screen.
Get/Set IP Address
By typing ‘GET 0 IPADDR
Substituting the ‘0’ for a 1, 2, 3, etc will tell Nexia to reveal the IP Address for the device who’s
number is 1, 2, 3 etc. A ‘0’ asks for the IP Address of the Nexia you are currently connected to.
Note: You can only use a 1, 2, 3 etc if there is a system loaded into the Nexia’s. If it is a single
device system, the only device number will be 1.
197