Biamp LTR User Manual
Page 183
System Control
Example: With a returned GETL response of 405, divide by 10 (405 / 10 = 40.5), and
then subtract 100 (40.5 – 100 = -59.5dB)
For your reference, the SETL/GETL Table on the following page shows .5dB increments
converted into the SETL/GETL format.
Some Attributes do not support all commands. The
section defines which commands
support SET/SETL, GET/GETL, INC, or DEC functions. RECALL is only used on preset
commands. DIAL is only used on telephone dialing commands.
*When GET or GETL is used, a
will not need to be specified since GET/GETL is a request
command. A Value must be specified in order for strings with SET/SETL, INC, DEC, and
RECALL to work.
Note:
SETD, GETD, INCD, DECD, SETLD, and GETLD commands may be used when a ‘full
path’ serial response to the command is desired (see
). A ‘full path’ serial response
will provide identification of the target object, the original command, and the resulting value or
state.
169