Biamp LTR - Manual (Page 206)

Nexia Manual LTR
Value determines what a DSP block is being set to, incremented by, or decremented by. The
Attribute section will define which type of value the string will need in order to execute the NTP
string.
Example: INC 1 AMLVLIN 4 1 1
In an Automatic mixer input level string, the Value equal to 1 states that the fader is to be
incremented by 1 dB.
Example: SET 2 MMLVLIN 5 2 –100
In a matrix mixer input level string, the value is set to –100dB.
Example: RECALL 1 PRESET 1004
For a preset recall we are telling device 1 to recall the fourth preset.
*When GET is used, a Value will not need to be specified since GET is a request command. A
Value
must be set in order for SET, INC, DEC, and RECALL command strings to work.
Example: GET 4 MMLVLOUT 5
We are asking the level of a matrix mixer’s output. There is no Value required for this string.
Responses
When a successful SET, SETL, INC, DEC, or RECALL command is sent to an Nexia device via
RS-232 or Telnet, Nexia will respond with: ‘+OK’ followed by a carriage return and line feed.
Example: Sending the string: SET 2 AMLVLIN 4 2 1 < LF> will result in an: +OK
response.
A successful GET or GETL command will result in a numerical response to the command string
followed by .
The response from an NTP string with a GET command may contain a decimal point (with 4
numbers after the decimal) and/or negative numbers, depending on type of Attribute addressed. If
the control system does not support negative numbers or decimal places a GETL command may
be used instead (see page 6).
Example: After sending the above example to an Nexia device the string:
192