Tc - input 2 channel – Biamp LTR User Manual
Page 113
Component Objects
When placing a Nexia TC into the Layout, the TC – Pre-
AEC 8 Channel
block is optional. It provides the same set
of input signals as the
However, the signals are derived from the input preamp
directly, and are not affected by AEC or Noise Reduction
processing. Pre-AEC input signals can be used to feed
‘local’ outputs, while the AEC input signals are used to feed
the ‘far end’ (
).
Device IO
indicates which hardware input is associated
with that software channel. Peak In should flash only
occasionally (6dB headroom), as determined by
Gain In settings. Mute In turns the input signal on/off. Level
(dB) In
adjusts the relative input volume. Invert In reverses
the polarity of the input signal.
Right-clicking over certain settings will provide a menu of
additional options.
Each NEXIA TC comes pre-configured from the factory with
a
. If you wish to load your own
custom designed configuration you will need to
the unit(s) first.
TC - Input 2 Channel
NEXIA TC hardware is represented in the Layout with as many as seven
separate blocks. Between these blocks can be placed virtually any of the
other available NEXIA mixing, routing, and processing blocks (component
objects). Like other component objects, NEXIA TC blocks can be placed
into the Layout either from the
. To access TC –Input 2 Channel settings, double-click over the
corresponding block in the Layout. This opens a Control Dialog Box which
provides all available settings.
Device IO
indicates which hardware
input is associated with that software
channel. Gain In compensates for
different input levels (mic or line), and
should be set so Peak In flashes only
occasionally (6dB headroom). Phan
Pwr
assigns +48 Volt phantom power
to the input for condenser
microphones. Mute In turns the input
signal on/off. Level (dB) In adjusts the
relative input volume. Invert In
reverses the polarity of the input
99