Biamp LTR - Manual (Page 167)

System Design
Messages: The algorithm for the '__' block (object code '__') at [__,__] has been eliminated.
You should replace the existing block with a newly created one which uses the
most up to date algorithm.
You should replace the existing blocks with newly created ones which use the
most up to date algorithms.
Explanation: These messages are similar to the ones above. The difference is that they are
not warnings, but errors.
Message: Nothing to compile !
Explanation: All objects placed in layout have been ignored.
Message: Feedback loop detected.
Explanation: The potential exists for an audio path to be indirectly looped back
upon itself. This condition could be dangerous, and is not allowed.
Allocation of DSP blocks to NEXIA Devices
Message: The allocation of some DSP blocks cannot be resolved. You
should use NexLink I/O blocks to pass audio signals between units.
Explanation: This system design attempts to pass audio signal(s) from one
Nexia unit to another. Use a pair of NexLink Input and Output
blocks to accomplish this.
Message: Too many resources required in the unit #_.
Too many resources required in the units ##_.
Explanation: The design requires more DSP resources than are available
from the Nexia device(s) specified in the Equipment Table .
Message: Due to insufficient DSP resources all disjoint blocks have been ignored.
Explanation: There are not enough DSP resources available in any Nexia unit in the
153