HP Anab EQ5 - Manual (Page 3)

EQ5 AC Drive Operations Manual
_______________________________________________________________________
TECO – Westinghouse Motor Company Compliance with UL
Instructions on wiring:
Danger
• Connect the inverter to power via a line-protection molded-case circuit breaker or fuse, otherwise fire may
result.
• Always connect a ground wire, otherwise electric shock or fire may result.
• A licensed specialist must perform the wiring, otherwise electric shock may result.
• Turn off the power before starting the wiring, otherwise electric shock may result.
• Wire the inverter after installation is complete, otherwise electric shock or injury may occur.
Caution
• Confirm that the phases and rated voltage of this product match those of the AC power supply, otherwise
injury may result.
• Do not connect the AC power supply to the output terminals (U,V,and W), otherwise injury may result.
• Do not connect a braking resistor directly to the DC terminals (P(+)and N(-)),otherwise fire may result.
• Ensure that the noise generated by the inverter, motor, or wiring does not adversely affect peripheral
sensors and equipment, otherwise accident may result.
Instructions on operation:
Danger
• Be sure to install the surface cover before turning on power (closed). Do not remove the cover while
power to the inverter is on. Otherwise electric shock may occur.
• Do not operate switches with wet hands, otherwise electric shock may result.
• When the retry function is selected, the inverter may restart automatically after tripping. Design the machine
to ensure personal safety in the event of restart. Accident may result.
• When the torque limiting function is selected, operating conditions may differ from preset conditions
(acceleration/deceleration time or speed). In this case, personal safety must be assured. Otherwise
accident may result.
• As the STOP key is effective only when a function setting has been established, install an emergency
switch independently, and when an operation via the external signal terminal is selected, the STOP key on
the keypad panel will be disabled. Otherwise accident may result.
• As operations start suddenly if an alarm is reset with a running signal input, confirm that no running signal
is input before resetting alarm. Otherwise accident may result.
• Do not touch inverter terminals when energized even if inverter has stopped. Otherwise electric shock
may result.
Caution
• Do not start or stop the inverter using the main circuit power. Failure may result.
• Do not touch the heat sink or braking resistor because they can be extremely hot. Burns may result.
• Carefully check the performance of motor or machine before operating at high speed. Injury may result.
• Do not use the inverter braking function for mechanical holding. Otherwise injury may result.