HP Anab EQ5 - Manual (Page 9)

EQ5 AC Drive Operations Manual
_________________________________________________________________________
TECO – Westinghouse Motor Company Receiving, Handling, and Storage 3
Temporary Storage
For drives 40HP/CT, 50HP/VT or more, loosen the mounting screws of the digital operator and remove
using the finger holds on the digital operator case (see Fig. 1-3-4).
Fig. 1-3-4 Removing the Digital Operator (40HP/CT, 50HP/VT or more)
1-4 Carrying and Moving the Product
1. Carry the product by the main body.
Do not carry the product while holding the cover or parts other than the main body.
2. Use a crane or hoist to carry a product equipped with handling hooks.
1-5 Storage
Temporary storage of this product must meet those conditions listed in Table 1-5-1.
Table 1-5-1 Storage Environment
Item Specifications
Ambient
temperature
-10 (14°F) to +50 (122°F)
Condensation or freezing must not occur as
a result of sudden temperature changes. Storage
temperature
-25 (-13°F) to +65 (149°F)
Note1
Relative
humidity
5 to 95%
Note2
Atmosphere
The product must not be exposed to dust, direct sunlight, corrosive gas, oil
mist, vapor, or water. There must be a minimum salt content in the
atmosphere. Do not store where condensation may occur as a result of
sudden changes in temperature.
Note1: The storage temperature applies only to short periods of time such as when transporting
the equipment .
Note2: As a large change in temperature within this humidity range may result in condensation or freezing,
do not store where such temperature changes may occur.
1. Do not place this product directly on a floor.
2. To store the product in an extreme environment, pack in vinyl sheeting, etc.
3. If the product is stored in a high-humidity environment, insert a drying agent (e.g., silica gel)
and pack the product in vinyl sheeting.