beautypg.com

K solve calculations, K solving an, Function – Casio FX-CG10 User Manual

Page 72

background image

2-26

Example 2

To simplify

27
63

specifying a divisor of 9

=

27
63

3
7

A$chcgdw

K4(CALC) 6( g) 6( g) 3(Simp) j

w

• An error occurs if simplification cannot be performed using the specified divisor.

• Executing

'Simp while a value that cannot be simplified is displayed will return the original

value, without displaying “F=”.

k Solve Calculations

[OPTN] - [CALC] - [Solve]

The following is the syntax for using the Solve function in a program.

Solve(

f

(

x

),

n

,

a

,

b

) (

a

: lower limit,

b

: upper limit,

n

: initial estimated value)

There are two different input methods that can be used for Solve calculations: direct
assignment and variable table input.

With the direct assignment method, you assign values directly to variables. This type of input is
identical to that used with the Solve command used in the Program mode.

Variable table input is used with the Solve function in the Equation mode. This input method is
recommended for most normal Solve function input.

An error (Time Out) occurs when there is no convergence of the solution.

For information about Solve calculations, see page 4-4.

• You cannot use a second derivative,

Σ , maximum/minimum value or Solve calculation

expression inside of any of the above functions.

• Pressing

A during calculation of Solve (while the cursor is not shown on the display)

interrupts the calculation.

k Solving an

f

(

x

) Function

[OPTN] - [CALC] - [SolveN]

You can use SolveN to solve an

f

(

x

) function using numerical analysis. The following is the

input syntax.

SolveN (left side [=right side] [,variable] [, lower limit, upper limit])

• The right side, variable, lower limit and upper limit all can be omitted.

• “left side[=right side]” is the expression to be solved. Supported variables are A through Z,

r

,

and

θ . When the right side is omitted, solution is perform using right side = 0.

• The variable specifies the variable within the expression to be solved for (A through Z,

r

,

θ ).

Omitting a variable specification cause X to be used as the variable.

This manual is related to the following products: