Casio FX-CG10 - Manual (Page 321)

8-37
• The following is a typical graph condition specification for a regression graph.
S-Gph1 DrawOn, Linear, List 1, List 2, List 3, Blue
The same format can be used for the following types of graphs, by simply replacing “Linear”
in the above specification with the applicable graph type.
Linear Regression .......... Linear Logarithmic Regression ...... Log
Med-Med......................... Med-Med Exponential Regression ...... ExpReg(a·eˆb x )
Quadratic Regression .... Quad ExpReg(a·bˆ x )
Cubic Regression .......... Cubic Power Regression ............... Power
Quartic Regression ........ Quart
• The following is a typical graph condition specification for a sinusoidal regression graph.
S-Gph1 DrawOn, Sinusoidal, List 1, List 2, Blue
• The following is a typical graph condition specification for a logistic regression graph.
S-Gph1 DrawOn, Logistic, List 1, List 2, Blue
• The following is a typical graph condition specification for a pie chart.
S-Gph1 DrawOn, Pie, List 1, %, None, ColorLinkOff, ColorAuto ColorLighter, ColorClr
• The following is a typical graph condition specification for a bar graph.
S-Gph1 DrawOn, Bar, List 1, None, None, StickLength, ColorLinkOff, Blue ColorLighter,
Black, Red ColorLighter, Black, Green ColorLighter, Black
To draw a statistical graph, insert the “DrawStat” command following the graph condition
specification line.
ClrGraph _
S-Wind Auto _
{1, 2, 3}
→ List 1 _
{1, 2, 3}
→ List 2 _
S-Gph1 DrawOn, Scatter, List 1, List 2, 1, Square, ColorLinkOff, ColorAuto _
DrawStat