Casio FX-CG10 - Manual (Page 301)

8-17
Stop
Function: This command terminates execution of a program.
Syntax: Stop
Description:
• This command terminates program execution.
• Execution of this command inside of a loop terminates program execution without an error
being generated.
k Jump Commands (JUMP)
Dsz (Count Jump)
Function: This command is a count jump that decrements the value of a control variable by 1,
and then jumps if the current value of the variable is zero.
Syntax:
Variable Value ≠ 0
Dsz :
_
:
^
Variable Value = 0
Parameters: variable name: A to Z, r ,
θ
[Example] Dsz B : Decrements the value assigned to variable B by 1.
Description: This command decrements the value of a control variable by 1, and then tests
(checks) it. If the current value is non-zero, execution continues with the next statement.
If the current value is zero, execution jumps to the statement following the multi-statement
command (:), display command (
^), or carriage return ( _).
Goto~Lbl
Function: This command performs an unconditional jump to a specified location.
Syntax: Goto ~ Lbl
Parameters: label name: value (0 to 9), variable (A to Z, r ,
θ )
Description:
• This command consists of two parts: Goto n (where n is a parameter as described above)
and Lbl n (where n is the parameter referenced by Goto n ). This command causes program
execution to jump to the Lbl-statement whose n parameter matches that specified by the
Goto-statement.
• This command can be used to loop back to the beginning of a program or to jump to any
location within the program.
• This command can be used in combination with conditional jumps and count jumps.
• If there is no Lbl-statement whose value matches that specified by the Goto-statement, an
error occurs.