Casio FX-CG10 - Manual (Page 561)

20100801 20100801
ε
-16
Using Advanced Setup
• To configure trigger threshold, trigger start edge, and trigger end edge
settings
Perform the following steps when “Period” is specified as the sampling mode (page
ε
-11).
1. Move the highlighting to “Threshold”.
2. Press
1(EDIT) to display a dialog box for specifying the trigger threshold value, which is
value that data needs to attain before sampling starts.
3. Input the value you want.
4. Move the highlighting to “Start to”.
5. Press one of the function keys described below.
To select this type of edge: Press this key:
Falling 1(Fall)
Rising
2(Rise)
6. Move the highlighting to “End Edge”.
7. Press one of the function keys described below.
To select this type of edge: Press this key:
Falling
1(Fall)
Rising
2(Rise)
8. Press
w to finalize Trigger Setup and return to the Advanced Setup menu (page
ε
-8).
• To configure PhotoGate trigger start and end settings
Perform the following steps when CH1 is selected as a Photogate trigger source.
1. Move the highlighting to “Start to”.
2. Press one of the function keys described below.
To specify this PhotoGate status: Press this key:
PhotoGate closed
1(Close)
PhotoGate open
2(Open)
3. Move the highlighting to “End Gate”.
4. Press one of the function keys described below.
To specify this PhotoGate status: Press this key:
PhotoGate closed
1(Close)
PhotoGate open
2(Open)
5. Press
w to finalize Trigger Setup and return to the Advanced Setup menu (page
ε
-8).