Yaskawa GPD503 Drive User Manual
Page 98
B. Procedure For Changing a Setting:
ACTION
DESCRIPTION
DISPLAY
Press
^
and
Value of
bn-XX
digits scrolls up or
v
Keys as
down by 1 each time one of these keys
Necessary
is pressed.
Until Display
EXAMPLE: Select bn-03, Accel. Time 2.
Shows Desired
Constant No.
Press DATA
Display shows the value currently stored in
ENTER
memory for the constant. NOTE: Factory
Key to Display
setting for bn-03 is
10.0
sec.
Current Setting
Press
>
,
^
Blinking position of display shifts to the
and
v
Keys
left. Value of blinking digit increases
as Necessary
or decreases when keys are pressed.
Until Display
EXAMPLE: Set bn-03 to
16.0 sec.
Shows Desired
Setting
Press DATA
Display lights steady for a short time,
ENTER
then
End
is displayed for approx. 1 sec.
to Store New
Then setting is displayed again, with one
Setting
digit blinking.
NOTE: If the setting being entered is
not within acceptable range for the
selected constant, the fault indication
"
E r r
" will appear instead of "
End
"
(the new setting was not written into
EPROM memory); then the display
again shows the value currently
stored in memory.
Press DSPL Key
Display returns to beginning of cycle
to Return to
for selection of setting number to be pro-
Setting Number
grammed (see preceding page).
Selection
b n - 0 3
1 0.0
1 6.0
1 6.0
E n d
1 6.0
b n - 0 3
3-6
3.4 PROGRAM MODE OPERATION Continued