Yaskawa GPD503 Drive User Manual
Gpd 503 technical manual
Table of contents
Document Outline
- TM4231 - GPD 503
- CONTENTS
- GPD 503 SIMPLIFIED START-UP PROCEDURE
- Horsepower Range
- WARNINGS AND CAUTIONS
- Section 1. INSTALLATION
- Section 2. PROGRAMMABLE FEATURES
- 2.1 GENERAL
- 2.2 ACCEL/DECEL TIME
- 2.3 AUTO REFERENCE CHARACTERISTICS
- 2.4 AUTO REFERENCE - LOSS DETECTION
- 2.5 AUTO-RESTART
- 2.7 CRITICAL FREQUENCY REJECTION
- 2.8 DC INJECTION BRAKING
- 2.9 DIGITAL DISPLAY SELECTION
- 2.10 DISPLAY - MONITOR (AT POWER-UP) SELECTION
- 2.11 ENERGY SAVING OPERATION
- 2.12 EXTERNAL FAULT INPUTS
- 2.13 FREQUENCY (AUTO) COMMAND BIAS/GAIN
- 2.14 FREQUENCY COMMAND UPPER & LOWER LIMITS
- 2.15 JOG REFERENCE
- 2.16 MOMENTARY POWER LOSS RIDE-THRU
- 2.17 MONITOR DISPLAY (DIGITAL OPERATOR)
- 2.18 MULTI-FUNCTION ANALOG INPUT (Term. 16)
- 2.19 MULTI-FUNCTION INPUT TERMINALS (Term. 5-8)
- 2.20 MULTI-FUNCTION ANALOG MONITOR OUTPUT (Term. 21 & 22)
- 2.21 MULTI-FUNCTION OUTPUT TERMINALS (Term. 9 & 10; 25-27)
- 2.22 OVERTORQUE DETECTION
- 2.23 SPEED COINCIDENCE
- 2.24 REMOTE/LOCAL AND REFERENCE SELECTION
- 2.25 RESET CODES: 2-WIRE, 3-WIRE INITIALIZATION
- 2.26 SLIP COMPENSATION
- 2.27 SOFT START (S-CURVE) CHARACTERISTICS
- 2.28 SPEED SEARCH
- 2.29 STALL PREVENTION
- 2.30 THERMAL MOTOR OVERLOAD PROTECTION
- 2.31 TORQUE COMPENSATION
- 2.32 V/f PATTERN - STANDARD
- 2.33 V/f PATTERN - CUSTOM
- 2.34 UP/DOWN FREQUENCY SETTING
- 2.35 SLIP COMPENSATION DELAY TIME
- 2.36 CARRIER FREQUENCY
- Section 3. DIGITAL OPERATOR
- Section 4. INITIAL START-UP (“LOCAL” CONTROL)
- Section 5. OPERATION AT LOAD
- Section 6. FAILURE INDICATION AND DETAILS
- Section 7. TROUBLESHOOTING
- Appendix 1. LISTING OF CONSTANTS
- Appendix 2. SPECIFICATIONS
- Appendix 3. GPD 503 CAPACITY
- Appendix 4. DIODE AND TRANSISTOR MODULE RESISTANCE TEST
- Appendix 5. GPD 503 DIMENSIONS
- Appendix 6. SPARES
- Appendix 7. DYNAMIC BRAKING CONNECTIONS
- REAR COVER
- CONTENTS