Yaskawa GPD503 Drive - Manual (Page 100)

B. Drive Operation From Digital Operator (Using Factory Settings):
ACTION DESCRIPTION DISPLAY
Apply Power DRIVE lamp is on.
The Frequency Reference (An-01) set
value appears.
Use > , ^ , Blinking position of display shifts to the
and v Keys left. Value of blinking digit increases
as Necessary or decreases when keys are pressed.
Until Display
Shows Desired
Run Frequency
Press DATA Key
Displayed value stops blinking for approx-
ENTER imately 2 seconds, then digit resumes
To Write New blinking.
Value Into
Memory
Press FWD Key
Observe FWD and REV indicator lamps on FWD REV
REV Digital Operator to see which direction
To Select Desired motor will rotate when GPD 503 is started.
Direction of EXAMPLE:
Motor Rotation FWD Run
selected
Press DSPL Key Present Output Frequency is
displayed.
Press and Hold Check motor operation at programmed
JOG Key Jog Frequency operating speed.
Release JOG GPD 503 output increases to Frequency
Key; Press Reference level, at programmed Accel Rate.
RUN Key Motor speed increases accordingly.
Press STOP Key Motor speed decreases under GPD 503
control, at preset deceleration rate, to zero.
Motor remains stopped.
F 0 0.0 0
F 6 0.0 0
F 6 0.0 0
F 6 0.0 0
0.0 0
0.0 0
6.0 0
6 0.0 0
3-8
3.5 DRIVE MODE OPERATION Continued